FRIGIDAIRE FGDS3065PF - Manual (Page 42)

42
CARE AND CLEANING
Removing the Warmer Drawer
To remove the warmer drawer:
1. Turn power OFF to the appliance before removing the
warmer drawer.
2. Open the warmer drawer completely.
3. On left warmer drawer rail, locate black release lever
and press up with finger while pulling out slightly on the
oven drawer handle. On right warmer drawer rail, locate
black release lever and press down with finger while
pulling out slightly on the warmer drawer handle
(
Figure 44 ).
4. The warmer drawer should now be released from the
rails. Remove warmer oven drawer (using level and
square motion) completely out and away from the appli-
ance.
To replace the warmer drawer:
1. Pull the bearing glides to the front of the outer compart-
ment glide channels until they snap into place (See
Figure 43).
2. Carefully line up both sides of the warmer drawer glide
rails to the outer compartment glide channels located
inside the empty warmer drawer compartment (See
Figure 44).
3. While holding the warmer drawer level and square
using the warmer drawer handle, push (do not force)
the warmer drawer all the way into the outer compart-
ment glide channels all the way into the range. Open
the warmer drawer again to verify the glides have
seated.
4. If you do not hear the levers “click” or the bearing glides
do not feel seated remove the warmer drawer and
repeat Steps 1 through 3 again. This will minimize
possible damage to the bearing glides.
Electrical shock hazard can occur and result in serious
injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
Figure 44: Removing the warmer drawer
WARNING
Left-hand rail and release
Warmer
drawer
handle
Right-hand rail and release
Figure 45: Bearing glide placement
Figure 46: Channel alignment
Left-hand channel
Right-hand channel