Acronis True Image for MS SBS Server - User Guide - Manual (Page 51)

When managing a group task, enter the same username and password you entered when
created the task.
4.4.4 Acronis Group Server options
Acronis Group Server regularly polls computers included in its database for their status
(Ready, Offline and so on, according to
4.4.1 Group status display. ) The default interval
between enquires is 2 seconds. You have an option to set the status refresh rate based
on your network requirements.
There is usually no need to refresh the view at all when the console is disconnected from
the group server. A separate option allows you to disable the polling on console
disconnection or set a wider interval between packets.
There is also an option to stop scanning network for newly connected computers. This
can speed up operations with the computers already discovered. After the scanning is
disabled, Acronis Group Server stops sending the packets, but the response may come to
the packets already sent. Therefore, some computers may be added to the computer list
after scanning is disabled. This is not a malfunction.
To adjust the status refresh rate, connect the console to the computer where Acronis
Group Server is installed and select Tools -> Options -> Network -> Status check
interval.
4.5 Managing backup server
Before you start managing the backup server, be sure to read section 3.5 Acronis Backup
Server stating the basic operating principles of this application.
When connected to a computer where Acronis Backup Server is installed, click Acronis
Backup Server management to display the following window.
Copyright © Acronis, Inc., 2000-2008 51