FRIGIDAIRE FFFW5000QW - Manual (Page 3)

Specifications
subject to change.
Specifications
subject to change.
USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca
Front Load Laundry - Washers
Frigidaire Affinity (All N & P Models)
Front Load Washer Specifications
• Product Shipping Weight (approx.) – 222 Lbs.
• An electrical supply with grounded three-prong receptacle is
required. The power supply circuit must be installed in accordance
with current edition of National Electrical Code (ANSI/NFPA 70) and
local codes & ordinances. (Do not use same circuit as dryer.)
• Voltage Rating – 120V / 60 Hz / 15 Amps
• Amps @ 120 Volts = 10 Amps
• Equipped with 120V 3-wire power supply cord, approx. 60" long.
• Always consult local and national electric & plumbing codes.
• To maximize detergent effectiveness, ambient temperature should
never be below 60° F.
• Can be installed alone, with or without optional 15" Pedestal Drawer, or
stacked below matching Frigidaire® Dryer, which requires installation of
optional Dryer Stacking Kit. (For installation details, refer to instructions
included with optional pedestal or stacking kit or on web.)
• Can be built in with matching Frigidaire® Dryer in under-counter,
recessed or closet installation. (Refer to Built-In Installations on this
page for cutout dimensions. For additional installation details, refer to
Product Installation Guide on web.)
• Closet installation requires vented door with 2 unobstructed louvered
openings, minimum 60 sq. in. each, located 3" from top and bottom of
door. Full-length 120 sq. in. opening also acceptable. Allow additional
1" clearance between fronts of units and closed door.
• Do NOT install in area exposed to dripping water or outdoor
weather conditions, or where gasoline or other flammables, including
automobiles, are kept or stored.
• Floor MUST be solid with 1" maximum slope. To minimize vibration or
movement, reinforcement of floor may be necessary. Do NOT install
on carpeted surface.
• Leveling legs supplied to level washer properly and reduce excessive
noise and vibration.
• H/C water faucets MUST be installed within inlet hose length of
washer’s water inlet and MUST be 3/4" to connect to inlet hoses.
• Water pressure MUST be between 30 and 120 psi with NOT more
than 10 psi pressure difference between hot and cold.
• Drain required with standpipe diameter of 1-1/4" min. and height of
24" min. / 96" max. above floor, capable of eliminating 17 gallons per
minute. Attached 59" drain hose can reach 74"-high standpipe. For
higher standpipe, optional Drain Hose Extension Kit available.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
• Dryer Stacking Kit – (PN # STACKIT4X).
• 15" Classic White Pedestal Drawer – (PN # CFPWD15W).
• Mobile Home Installation Kit – (PN # 137067200).
• Drain Hose Extension Kit – (PN # 137098000).
• 6' Stainless Steel Washer Fill Hose (2 pack) – (PN # 5305516562).
• 4' Rubber Washer Fill Hose (2 pack) – (PN # 5308815006).
Front Load Washer
FFFW5000QW 3.9 Cu. Ft. D.O.E.
FFFW5000Q 03/14 © 2014 Electrolux Home Products, Inc.