AAXA Technologies P3OO - Manual (Page 7)

Getting Started
1. Connect the power cord to the P300.
2. Connect the wall plug into the wall power source.
3. Switch the On / Off switch on the side of the projector to the “ON” position to enter
“standby” mode
4. Press POWER button on the keypad and hold for 2-3 seconds to start the projector
5
Powering ON the projector
Chapter 2
Powering OFF the projector
1. Press and hold the power button on the keypad for 3 seconds.
2. The optical engine should power off and the fan should stop spinning. The projector
is now in “stand by mode” and can be turned on using the remote control. “Stand by
mode” consumes a little bit of power
3. To fully turn off the projector, switch the On / Off switch on the side of the projector to
the “Off” position
Note: The P300 Projector battery does not charge when it is in operation.