Abu Garcia Revo Low Profile Reels - Manual (Page 7)

- Pitch Centrifugal Brake System (Inshore, S) -
The Pitch centrifugal brake uses six adjustable brake blocks (3 “spring loaded” and 3 “non
spring loaded” – labeled “PITCH”). As the spool spins under high revolution, centrifugal force
causes the spring loaded brake blocks to engage and move towards the outer edge of the spool.
This force helps prevent the spool from over running at the start of the cast. The “spring loaded”
brake blocks retract during the second stage of casting as the spool slows down to allow for
maximum distance. When set in the “on” position, the “non spring loaded” brake blocks
(labeled “PITCH”) work throughout the entire cast and do not retract as the spool slows down,
allowing for maximum control.
Access the adjustable pins by rotating the thumb screw counterclockwise until it disengages from
the sideplate. . After the thumbscrew has been unscrewed from the sideplate, gently pull on the
spring loaded thumbscrew to disengage it from the sideplate on the opposite side. Twist the
sideplate in an upward motion until it reaches the stop position. The sideplate can now be
removed.
Disengage (i.e. turn off) the centrifugal brake by sliding all pins towards the center of the spool
until they click into position (see picture). In this position, the brake blocks are locked in the off
position and will not move out away from the center of the spool. To engage this feature (i.e.
turn on the brake blocks) slide any combination of pins towards the outside of the spool until
they click into place. Any combination of brake blocks can be engaged or disengaged to apply
more or less brake pressure. For example, turn on all six blocks for the most pressure and turn
on just one or two for less pressure and more distance. When a brake block is engaged (i.e.
turned on) it should be able to move towards the outer edge of the spool.