Abu Garcia Revo Spinning Reels User Manual
Page 4
opposite direction. In the “off” position, the rotor will turn both forward and backwards
depending on what direction the handle is turned.
G. DRAG ADJUSTMENT
Control the amount of drag by turning the adjustment dial on the top of the spool. Rotate the dial
clockwise (right) to increase drag or counterclockwise (left) to decrease drag.
For best results the drag should be adjusted to approximately one-third of the breaking test of the
line being used with the exception of braided lines. This can be accomplished by tying the line
to a spring scale for precise adjustment. Make sure the reel is first mounted on a rod and the line
has been run though the rod guides before tying to the scale. The drag should always release
before the line reaches its breaking point. Factors such as line type, technique and fishing
conditions may require different settings. Any drag setting above half of the line strength risks
line breakage.
If a spring scale is unavailable, tie the line to a secure point and engage the anti-reverse. With
the rod tip up (about a 45 degree vertical angle), apply pressure by turning the handle. Gradually
tighten the drag adjusting knob on the top of the spool. When the line approaches its breaking
point, loosen the adjustment dial ¼ turn.
H. REEL FUNCTION
Basic Casting Technique – Capture the line between your forefinger and the rod. Open the bail
arm on the reel. Bring the rod backward so the tip reaches a point above and behind the
shoulder. Without stopping bring the rod back in front of the body in a single motion. Release
the line as the rod is brought forward so that the lure is launched slightly upward and outward
toward your target.
I. MAINTENANCE
As with any precision product, your Revo® reel will require regular maintenance. Gently rinse
the reel with fresh water, wipe it dry and lubricate according to the accompanying diagram
(picture of oil and grease points).
To keep your reel working at peak efficiency, clean and lubricate after each use. At least once a
season your reel should be disassembled for a thorough cleaning and re-lubrication. Refer to the
exploded parts view supplied with your reel. Reel maintenance kits can be purchased at your
local tackle store and include everything you need to properly service your reel. If you do not
wish to perform this work yourself any nearby
is fully qualified to do
this for you.