Cisco 1604 - Manual (Page 14)

3-14
Cisco IOS Dial Services Quick Configuration Guide
Chapter 3 Configuring the Cisco 1604 Router
Verifying DDR Configuration
Step 2 Enter the show dialer command. The following example shows that the Cisco 1604 has not placed any
calls yet, and there have been no failures. An ISDN interface is a dialer interface. Key statistics are
shown for each B channel:
robo-austin# show dialer
BRI0 - dialer type = ISDN
Dial String Successes Failures Last called Last status
14085551234 0 0 never -
0 incoming call(s) have been screened.
0 incoming call(s) rejected for callback.
BRI0:1 - dialer type = ISDN
Idle timer (120 secs) , Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is idle
BRI0:2 - dialer type = ISDN
Idle timer (120 secs) , Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is idle
Step 3 Enter the show dialer map command to see the static dialer map that was built to the Cisco AS5300.
This map is built by using the phone number and WAN IP address of the access server:
robo-austin# show dialer map
Static dialer map ip 10.1.254.1 name hq-sanjose (14085551234) on BRI0
Step 4 Enter the show running command to see the Cisco 1604’s current configuration:
robo-austin# show running
Building configuration...
Current configuration:
!
version 12.0
service timestamps debug uptime
service timestamps log uptime
service password-encryption
!
hostname robo-austin
!
aaa new-model
aaa authentication login default local
aaa authentication ppp default if-needed local
enable secret 5 $1$aZ1D$wNO71EpS6y5zRYuW9qFEr.
!
username joe-admin password 0 6y5zRYuW9qFEr$wNO71EpS6$aZ1
username hq-sanjose password 0 $wNO71EpS6y5zy5zRYuW9aZ1D$w
isdn switch-type basic-ni
!
interface Ethernet0
ip address 10.1.4.1 255.255.255.0
!
interface Serial0
no ip address
shutdown
!
interface BRI0
ip address 10.1.254.4 255.255.255.0
encapsulation ppp
dialer map ip 10.1.254.1 name hq-sanjose 14085551234
dialer load-threshold 60 either