Cisco 1604 - Manual (Page 5)

3-5
Cisco IOS Dial Services Quick Configuration Guide
Chapter 3 Configuring the Cisco 1604 Router
Step 2—Configuring Local AAA Security
interface Serial0
no ip address
shutdown
!
interface BRI0
no ip address
shutdown
!
ip classless
!
!
line con 0
line vty 0 4
login
!
Step 2 Log in with your new enable password.
Step 3 Exit out of enable mode by using the disable command.
The prompt changes from robo-austin# to robo-austin> .
Step 4 Enter the enable command followed by your password.
Step 5 Enter the show privilege command to show the current security privilege level, which is level 15:
robo-austin# disable
robo-austin> enable
Password:
robo-austin# show privilege
Current privilege level is 15
robo-austin#
Tips
If you have trouble:
• Make sure the Caps Lock key is off.
• Make sure you entered the correct password. Passwords are case sensitive.
Step 2—Configuring Local AAA Security
The Cisco IOS security model to use on all Cisco devices is authentication, authorization, and
accounting (AAA). AAA provides the primary framework through which you set up access control on
the access server.
• Authentication—Who are you?
• Authorization—What can you do?
• Accounting—What did you do?
In this case study, the same authentication method is used on all interfaces. AAA is set up to use the
local database configured on the Cisco 1604 router. This local database is created with the username
configuration commands.
Note Setting up your AAA security at this point in the configuration process is a matter of “best
practices”; it ensures that the configuration is managed for most effectiveness.