Vertical Communications Scout II - Manual (Page 25)

7.6 Using Call Waiting
•
To activate call waiting,
1. Make intercom call and receive busy signal.
2. Dial ✳ 0 1 (called party hears tone).
3. Wait on line for an answer.
•
To cancel call waiting,
1. Hang up handset.
•
To answer a call waiting tone,
1. Hear short tone burst in handset receiver.
2. Complete present call and hang up. (Waiting call will begin
ringing.)
3. Lift handset to answer.
7.7 Using Automatic Set Relocation
If this feature enabled by your system programmer, the message
waiting light will flash for several seconds when you connect your
telephone at another location. This means that the system is waiting to
automatically relocate your extension number and other programmed
features to the new location.
• To accept automatic relocation,
1. Do nothing and wait for the light to turn off on its own or press the
HOLD button to immediately accept the relocation (light
immediately turns off).
•
To reject automatic relocation,
1. Press the # button while the message waiting light is flashing. If
you do not press # before the light stops flashing, relocation is
accepted.
GCA70–246 Using The Other Telephone Features
Single Line Station User's Guide 7 – 5