Canon X-Loupe - Manual (Page 8)

page38 page39
Assembling Assembling
As picture shown on the left, tuck Canon digital camera
into X-Loupe module.
Make sure that the left and bottom edges of the Canon
digital camera are in close contact with X-Loupe module.
Make sure that the screw hole on the bottom of the module
is aligned with the tripod socket of the camera. Insert the
screw into the hole.
Rotate a coin clockwise to tightly lock the screw. Please
make sure that both Canon digital camera and the module
are well locked.
Hold the camera and module in one hand and take the
objective lens with the other hand. Align the red dot on
the objective lens with the other red dot on the module.
Attach the objective lens to the module.
Rotate the objective lens clockwise until the sound, ｀ka´,
is heard. Do not over-rotate the objective lens.
For the safety purpose, please make sure that the objective
lens is not loose.
To change the objective lens, press
the release button and rotate the
objective lens counterclockwise for
45 degrees. Easily and softly disas-
semble the objective lens from the
module. Do not over-rotate the
To disassemble X-Loupe module from Canon digital camera, rotate a coin counterclock-
wise. Pay attention to both camera and module to prevent them from falling . Please store
the screw in a proper place, It
is advised to put it back into the carrying case. objective lens. Repeat above procedures to assemble another objective lens onto the
module.