Chauvet SLIMPAR 56 - Manual (Page 6)

Page 6 of 17 SlimPAR™ 56 User Manual (Rev. 02)
3. S
ETUP
AC Power
This product has an auto-ranging power supply and it can work with an input voltage range of
100~240 VAC, 50/60 Hz.
To determine the power requirements for a particular fixture, see the label affixed to the back
plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating
indicates its average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse), making sure
that it has an appropriate electrical ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
Power Linking
This fixture provides power linking via the Edison outlet located in the back of the unit. Please
see the diagram below for further explanation.
Power Linking
Diagram
You can power link up to 81 SlimPAR™ 56 units on 120 VAC or up to 143 SlimPAR™ 56
units on 230 VAC.
The power linking diagram shown above corresponds to the North American version of
this product ONLY! If using this product in other markets, you must consult with the local
CHAUVET® distributor as power linking connectors and requirements may differ in your
country or region.
Generic Fixture Housing
1 st Fixture 2
nd
Fixture 3 rd Fixture
To other fixtures