Cooper Bussmann BU-905U-L-R - Manual (Page 5)

www.cooperbussmann.com/BussmannWirelessResources
Cooper Bussmann BU-905U-L-R Receiver Quick Start Guide
Antenna Installation
Resetting Your Unit to Factory Defaults
You must reset the receiver unit to factory defaults before linking the transmitter and receiver units.
To reset the default factory configuration:
1. Press and hold the RSSI push button.
2. Power on the BU-905U-L-R receiver.
3. The BU-905U-L-R receiver flashes all LEDs at medium flash (i.e., 1.6Hz).
NOTE: If the LEDs do not flash, you must repeat steps 1 and 2 until the LEDs flash before continuing.
4. Release the RSSI push button within 5 seconds.
5. Within a further 60 seconds, press and hold the RSSI push button for 5 seconds (until the LEDs stop flashing) and then release.
6. The BU-905U-L-R receiver lights all LEDs for 2 seconds before returning to normal operation.
NOTE: If the LEDs do not light, you must repeat the process from step 1 until the LEDs light before continuing.
7. You can now link the transmitter and receiver units.
5 3A1578Rev1.9