Dell PowerVault 220S (SCSI) - Manual (Page 2)

www
.dell.com | support.dell.com
1 Turn off the storage system.
This step is optional if I/O activity to the storage system has ceased.
2 Remove the host server-to-storage system cable from the EMM.
For removal instructions, see your Installation and Troubleshooting Guide.
3 Using a #2 Phillips-head screwdriver, loosen the captive screw at the top of the EMM
(see Figure 1).
4 Grasp the handle of the module and pull it from the module slot.
NOTE: If you did not turn off power to the storage system in step 1, after the module
is removed from the system, the amber shelf fault light illuminates and, if enabled, an
alarm might beep until the module is replaced.
F i g u r e 1 . R e m o v i n g a n d I n s t a l l i n g a n E M M
Installing an Ultra 320 EMM
CAUTION: Before performing any of the procedures listed in this section, read
and follow the safety instructions in the System Information Guide that shipped
with your computer.
1 Carefully insert the Ultra 320 EMM into the empty module slot.
NOTE: You can identify the Ultra 320 EMM by the SCSI Ultra 320 label on it.
captive screw
handle
secondary EMM
or SCSI terminator card
primary EMM
3W495eb0.fm Page 2 Monday, April 7, 2003 11:12 AM