Cambridge SoundWorks PS2000 - Manual (Page 12)

7
1. MUTE (On Remote Control): Mutes all output from the PS2000
Digital . Press this button once to mute. Press a second time to restore
audio output. You can also enable or disable the mute function by pressing
volume buttons on the Dipole Unit together.
2. POWER ON/OFF (On Subwoofer) : The POWER button on the
Subwoofer controls the power supply input from the Power Adapter. This
button must be depressed to activate the Dipole Unit.
3. POWER (On Remote Control): The POWER button on the Remote
Control and Dipole Unit sets the system to power on and standby mode.
When the system is turned on for the first time, the default input mode is
“Digital” and the effects selection is “Prism”. Subsequently, when the
system is turned on from standby mode, the last input mode and effect
selection is retained.
4. VOLUME (On Dipole Unit): Adjusts the volume of the entire system.
Press the UP or DOWN button to increase or decrease the volume. (This
function is also available on the Remote Control, use the + or - button)
5. DIGITAL (On Remote Control) : Selects the digital input source signal
for the OPTICAL or COAXIAL input. Digital input is the default mode when
the system is turned on. Optical input has priority. This button is located
on the Remote Control. (This function is also available on the Dipole Unit,
use the SOURCE button) The possible digital input signals are; PCM, 2-Ch
AC-3 or 5.1 AC-3. These signals are auto-detected.
PCM 2-Ch AC-3 5.1 AC-3
PS2000 Digital_Final_01082000.fm Page 7 Tuesday, August 1, 2000 1:26 PM