Vermont Casting 3405BGW - Manual (Page 9)

Hardware:
Tools needed:
Assembly Step 4
Locate these parts:
Phillips Head
Screwdriver
1. Set the burner assembly onto the cabinet as
shown. IMPORTANT: The burner tube must
slide properly onto the valve stem as shown
below.
2. Secure the burner assembly with the three bolts
from the inside of the cabinet. Securely tighten
the bolts.
3. Attach the loose igniter wire to the igniter on the
control panel as shown below.
9
Burner
Assembly
HARDWARE BAG B
1/4-20 x 1/2” Bolts
3 Required