Canon imageCLASS MF4100 Series - Manual (Page 12)

21
Installing/Uninstalling Software
Installation Procedure
Before Installation: System Requirements
Microsoft Windows 98/98SE
CPU: Intel
® Pentium ® 90 MHz or higher
Memory: 128 MB or more
Microsoft Windows Me
CPU: Intel
® Pentium ® 150 MHz or higher
Memory: 128 MB or more
Microsoft Windows 2000
CPU: Intel
® Pentium ® 133 MHz or higher
Memory: 128 MB or more
Microsoft Windows XP (32-bit version)
CPU: Intel
® Pentium ® II/Celeron ® 300 MHz or
higher
Memory: 128 MB or more
• Do not connect the USB cable before installing the
software. If you connect the USB cable before
installing the software and the Found New Hardware
Wizard screen appears, click [Cancel] and
disconnect the USB cable.
• For Windows 2000/XP, log on as an Administrator to
install the software.
• Make sure the machine is turned on before
connecting the USB cable.
• On the screen shown at each step, click on the
circled button to proceed.
1 2
If the MF4100 Series CD-
ROM Setup screen is not
displayed, click [start] on the
Windows task bar
→ [My
Computer] (Windows 98/Me/
2000: double-click [My
Computer] on the Windows
desktop). Open the CD-ROM
icon, then double-click [MInst]
([MInst.exe]).
3
NOTE
If the disk space is insufficient to
install the software, an error
message is displayed. Free the
disk space, and then try again.
4 5 6 7
8 9 10 11 12
22