Craftsman G8693 - Manual (Page 19)

G8693 Mini Shaper -19-
Figure 16.
Do not use the Mini Shaper to reduce workpiece
size. The workpiece should be cut as close to
final size before shaping. For best results, run all
sides to be shaped through a jointer.
Whenever a cutter is required to make a heavy
cut, the spindle speed (RPM) may be reduced.
This results in a rough or splintered cut.
Excessive depth-of-cut can also cause kickback!
Always make a test cut on a piece of scrap before
using the finished workpiece.
Workpiece Prep
The Shaper cutter runs at high RPM, so with most
woods it makes little difference if the cut is with or
against the grain. However, with some very open
grained woods such as redwood or fir, cutting
against the grain may result in a rough, splintered
surface. In this situation and when a heavy cut
must be made, it is advisable to make a series of
light cuts. Make the final cut by removing
1 ⁄
16
'' or
less material.
Wood Grain