Harbor Freight Tools Model 40400 - Manual (Page 2)

SKU 40400 For technical questions, please call 1-800-444-3353. Page 2
SAvE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, operating, inspection,
maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual.
Write the invoice number on the inside of the front cover. Keep this manual and invoice in a safe and dry place
for future reference.
GENERAL SAFETY WARNINGS AND PRECAUTIONS
Motor Single Phase, 120 V~, 60 Hz, 15.5 A, 3,360 RPM
Air Tank 8 Gallon
Pump Type Single Stage
Max. Working Pressure 115 PSI
Air Flow
6 SCFM at 40 PSI, 5 SCFM at 90 PSI,
4.2 SCFM at 115 PSI
Press Switch 70 PSI
Materials
Cast Iron Piston and Connecting Rod
Cast Aluminum Crankcase
Piston Diameter 1.886”
Cylinder Honing 45° Crosshatch
Overall Dimensions 26” x 11-3/4” x 27”
Outlet Fittings 1/4” – 18 NPT
REv 01j; 03h; 09c
1. KEEP WORK AREA CLEAN AND DRY. Clut-
tered, damp, or wet work areas invite injuries.
2. KEEP CHILDREN AWAY FROM WORK AREA.
Do not allow children to handle this product.
3. STORE IDLE EQUIPMENT. When not in use,
tools and equipment should be stored in a dry
location to inhibit rust. Always lock up tools and
equipment, and keep out of reach of children.
4. DO NOT USE THIS PRODUCT IF UNDER
THE INFLUENCE OF ALCOHOL OR DRUGS.
Read warning labels on prescriptions to deter-
mine if your judgement or reflexes are impaired
while taking drugs. If there is any doubt, do not
attempt to use this product.
5. USE EYE AND HAND PROTECTION. Wear
ANSI-approved safety impact goggles and
heavy-duty work gloves when using this prod-
uct.
6. DRESS SAFELY. Do not wear loose cloth-
ing or jewelry, as they can become caught in
moving parts. Wear a protective hair covering
to prevent long hair from becoming caught in
moving parts. If wearing a long-sleeve shirt,
roll sleeves up above elbows.
7. DO NOT OvERREACH. Keep proper footing
and balance at all times to prevent tripping,
falling, back injury, etcetera.
8. INDUSTRIAL APPLICATIONS MUST FOL-
LOW OSHA REQUIREMENTS.
9. STAY ALERT. Watch what you are doing at all
times. Use common sense. Do not use this
product when you are tired or distracted from
the job at hand.
10. CHECK FOR DAMAGED PARTS. Before
using this product, carefully check that it will
operate properly and perform its intended func-
tion. Check for damaged parts and any other
conditions that may affect the operation of this
product. Replace or repair damaged or worn
parts immediately.
11. REPLACEMENT PARTS AND ACCES-
SORIES: When servicing, use only identical
replacement parts. Only use accessories
intended for use with this product. Approved
accessories are available from Harbor Freight
Tools.
12. MAINTAIN THIS PRODUCT WITH CARE.
Keep this product clean and dry for better and
safer performance.
SPECIFICATIONS