Combi 8100 - Manual (Page 25)

47
To change harness strap slots:
1. Buckle shoulder harness straps and chest clip.
2. From front of car seat, loosen shoulder
harness straps by pressing harness adjuster
lever and pulling harness straps out to
lengthen them.
- Make sure both buckle tongues are
buckled and chest clip is closed.
3. From back of car seat, remove both
metal harness strap clips from adjuster
loop (fig. f).
4. From front of car seat, pull shoulder
harness straps through car seat shell,
seat pad and infant insert pad (fig. g).
(fig. f)
Metal Harness
Strap Clips
(fig. g)
Adjuster
Loop
To Re-secure Shoulder Harness Straps:
1. From front of car seat, rethread shoulder
harness straps through desired shoulder
harness strap slots of infant insert, seat
pad and seat back. Make sure shoulder
harness straps are not twisted and are
threaded through matching slot of seat
pad and seat back.
NOTE: Only use two lowest sets of shoulder
harness slots with infant insert.
2. From back of car seat make sure shoulder
straps are not twisted, pull shoulder
harness straps down and re-attach
harness strap metal clips to adjuster
loop as shown in fig. h.
NOTE: Openings in both metal
clips MUST be toward
center of car seat.
WARNING
DEATH or SERIOUS INJURY can occur
• Shoulder harness straps MUST be through belt slots in infant
insert.
• Do not use infant insert with top slots in car seat.
48
(fig. h)
Adjuster
Strap
Loop
Opening