Cabletron Systems 1200 - Manual (Page 53)

Workgroup Remote Access Switch 53
IP R OUTING N ETWORK WITH R EMOTE B RIDGE D EVICES
Configure the CyberSWITCH
You will then be prompted to verify your input. Make changes if necessary, or, if original input
correct, continue with configuration for RLAN interface.
Press 1 to add the next interface. Configure the information for the WAN (RLAN) interface as
follows:
1) LAN
2) WAN
3) WAN (Direct Host)
4) WAN (RLAN)
5) WAN (UnNumbered)
Select Option or press <RET> for previous menu: 1
INTERFACE NAME or <RET> to cancel? CorpOffice
Enter the IP Address in dotted decimal notation
or <RET> to cancel? 128.1.1.1
Enter the number of significant bits for the Subnet Mask
[default = 16]? <RET>
Enter the packet encapsulation type 1) for ETHERNET 2) for SNAP
[default = ETHERNET]? <RET>
Enter the MTU size in bytes [default = 1500]? <RET>
Transmit Broadcast Address:
1) 128.1.255.255
2) 128.1.0.0
3) 255.255.255.255
4) 0.0.0.0
5) Specify Explicitly
Enter a Transmit Broadcast Address [default = 1]: <RET>
RIP Send Control:
1) Do Not Send.
2) RIP Version 1.
3) RIP Version 1 Compatibility.
4) RIP Version 2.
Enter RIP Send Control [default = 2]: <RET>
RIP Receive Control:
1) Do Not Receive.
2) RIP Version 1 Only.
3) RIP Version 2 Only.
4) RIP Version 1 or Version 2.
Enter RIP Receive Control [default = 4]: <RET>
RIP Respond Control:
1) Do Not Respond.
2) RIP Version 1 Only.
3) RIP Version 2 Only.
4) RIP Version 1 or Version 2.
Enter RIP Respond Control [default = 4]: <RET>
RIP Version 2 Authentication Control:
1) No Authentication.
2) Simple Password.
Enter a RIP Authentication Control [default = 1]: <RET>