Cobra Electronics CP-2505 - Manual (Page 11)

TALK + MEMORY + I.D.# = MEMORY DIAL
0-9
HEARING AID COMPATIBILITY
Your cordless telephone handset is compatible with inductively coupled
hearing aids (HAC).
HOLD
After you put a call on hold, your Intenna automatically releases when you, or
someone else, picks up another handset on the same line. No need to come
back and turn it off, because it turns itself off automatically.
SYSTEM
The revolutionary, patented Intenna hidden-antenna system is a Cobra exclusive.
Intenna is the world’s first and only full-range-power cordless telephone that con-
ceals the handset and base antennas inside the phone and out of the way. No more
antennas to extend, bend or break. Cobra’s hidden antennas are perfectly matched
to your phone’s microprocessor circuitry for optimum performance offering the
ultimate in user-friendly convenience.
LAST NUMBER REDIAL
Each time you dial, the phone number you’re calling is automatically saved in a
special REDIAL memory. To call that number again at a busy signal, press
FLASH (without hanging up) to get a new dial tone, then press and release the
REDIAL button. If you wish to try the call in a few minutes, use TALK to access
the dial tone, then press and release the REDIAL button. The number will
automatically be redialed.
MEMORY DIALING (STORAGE)
Your Cobra Intenna cordless phone enables you to store up to ten frequently
dialed phone numbers or emergency numbers. With the TALK indicator light off,
press and release the MEMORY button ; enter the digits of the phone number you
wish to store, up to 16 digits; press and release the MEMORY button again. Now
assign your memory number a position by entering any keypad number from 0
to 9. You will hear a confirmation beep. Repeat until all ten numbers are entered.
NOTE: for automated banking or alternate long distance service, you may need
to program a number which is longer than 16 digits. You will need to divide the
number between two memory I.D. numbers. Follow the steps above.
MEMORY + TELEPHONE + MEMORY + I.D. # = CONFIRMATION
NUMBER (0–9) TONE
MEMORY DIALING (RECALL)
To call a number stored in memory, press TALK to get a dial tone; press MEMORY
button. Press the keypad number you assigned to that number and your phone will
automatically dial the number. NOTE: for longer numbers which you have stored
in two different I.D. numbers, follow steps above, pressing MEMORY button again
before entering the second number. Use the memory sticker card provided to write
down the names of each memory position. Keep this in any covenient place.
10
2505.MANUAL.pm 11/7/97, 11:43 AM 11