Chauvet HAZER 2 - Manual (Page 9)

Arena Hazer™ 2 User Manual
9 4/20/2010 4:23 PM
4. O
PERATING
I
NSTRUCTIONS
Configuring the Starting Address
Each fixture requires a starting address from 1~512. A fixture requiring one or more channels for
control begins to read the data on the channel indicated by the starting address. For example, a
fixture that uses seven DMX channels and is addressed to start on DMX channel 100, will read data
from channels: 100, 101, 102, 103, 104, 105 and 106. Choose the starting addresses for each fixture
so that the channels used do not overlap. In addition, you should note the starting address selected
for future reference.
The Arena Hazer ™ 2 fixture uses two DMX channels. If this is your first time using DMX, we
recommend reading the “DMX Primer” section in the “Appendix”.
Control Panel Functions
Access control panel functions using the six buttons located underneath the LCD Display on the
included wired remote.
The Control Panel shows the current state of the unit. It also has a sub-menu, which is used for
setting the DMX starting address.
You may select any combination of incremental fan speed and haze output, using the respective <+>
and <-> buttons. If an immediate full fan speed and maximum haze output is desired, press <FULL>.
This is a latching button.
Button Function
<FAN/ADDRESS +/->
Used to select incremental
fan speed, as well as
select the DMX address in
address selection mode
<HAZE +/->
Used to select incremental
haze output
<FULL>
Latching full fan speed
and haze output
<FUNCTION>
Used to select to DMX
address selection mode