Cadet 5F1250-8 User Manual

The cadet electric baseboard, Owner’s guide, Important instructions save these instructions

Advertising
background image

240/208 VOLT MODELS

2F350

6F1500

2F500

8F2000

3F750

8F2500

4F1000

8F2025

5F1250

10F2500

208 VOLT MODELS

2F500-8

3F750-8

4F1000-8

5F1250-8

6F1500-8

8F2000-8

8F2500-8

120 VOLT MODELS

2F500-1

3F750-1

4F1000-1

6F1500-1

The Cadet

Electric Baseboard

OWNER’S GUIDE

IMPORTANT INSTRUCTIONS

SAVE THESE INSTRUCTIONS

WARNING!

Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
lock or tag the panel board door to prevent
someone from turning on power while you are
working on the heater. Failure to do so could
result in serious electrical shock, burns, or
possible death.

CAUTION - High Temperature. Keep electrical cords, drapes,
and other furnishings away from heater.

When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock,
and injury to persons, including the following:

1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical supply

wires are the same voltage as the heater.

3. All electrical work and materials must comply with the

National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.

4. The heater must be grounded to one of the grounding screws

provided.

5. If you need to install a new circuit or need additional wiring

information, consult a qualified electrician.

6. Protect electrical supply from kinks, sharp objects, oil,

grease, hot surfaces or chemicals.

7. Do not place heater against paperboard or low-density

cellulose fiberboard surfaces.

8. Do not place heater below an electrical convenience receptacle.

9.

WARNING

Overheating or fire may occur. Do not install the heater
behind doors.

10.

WARNING

Fire or explosion may occur. Heater has hot and arcing or
sparking parts inside. Do not install heater in any area where
combustible vapors, gases, liquids, or excessive lint or dust
are present.

11.

WARNING

Burn Hazard. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids and
whenever the heater is left operating unattended. Keep
combustible materials, such as furniture, pillows, bedding,
papers, clothes, and curtains away from heater.

12.

WARNING

Risk of electrical shock. Do not insert or allow foreign
objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.

13.

WARNING

Risk of Fire. Do not block heater. To prevent a possible fire, do
not block air intakes or exhaust in any manner. Heater must
be kept clear of all obstructions: minimum of 12 inches in front
and above, 6 inches on both sides. Heater must be kept clean
of excessive lint, dirt and debris (See Maintenance Instructions).

14.Use this heater only as described in this manual. Any other

use not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.

Features & Benefits

Oversized high temperature limit switch with full
length sensor for added safety

Durable steel sheathed element with a limited
lifetime warranty

Easy installation with pre-punched case at 1” intervals

Rugged steel construction

Thermostat not included

www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675

TOOLS REQUIRED

Phillips
Screwdriver

Straight
Screwdriver

Wire Strippers

Drill or Hammer

Drill Bits

(4) Wood Screws

Wire Connectors

(1) Strain Relief
Connector

1

Advertising
This manual is related to the following products: