Clarke Encore S20E User Manual

Page 20

Advertising
background image

Page -20-

CLARKE TECHNOLOGY Operator's Manual -Encore S20E

REAR BLADE

.06

How To Adjust The Squeegee cont.

Adjusting Squeegee Tilt:
The tilt of the squeegee causes the rear blade to raise up
in the center or on the ends, depending on which
direction the tilt is changed. For tilt adjustment, refer to
figure 9. Loosen left and right screw "X". In order to
bring the rear blade down in the center, tip "Y" down. To
bring both ends down, tip "Y" up. Make very small
adjustments and try it until a uniform flare is achieved.
Changing the tilt may also require readjusting the squee-
gee pressure.

Adjusting Squeegee Blades:
When properly installed the front blade should be ap-
proximately .06 above the rear blade. See figure 10.

Adjusting Squeegee Support Wheels:
The support wheels should be set at .12 above the floor
with the rear blade touching the floor. See figure 10.

WARNING: Maintenance and repairs must

be done by authorized person-
nel only .

WARNING: Electrical repairs must be

done by authorized personnel
only.

Consult your Clarke Technology Authorized Service
Person to do the service procedures.

Use only genuine Clarke Technology parts.

NOTE: ONLY AUTHORIZED TRAINED PERSONNEL
DO THE FOLLOWING:

How to replace float switch, check ballast tanks,
and vacuum motor. (See Figure 11)

1. Remove the power cord from wall outlet.

2. Open the recovery tank/solution fill lid.

3. Using a Phillips screw driver, remove the retainer and

the screw.

4. Perform the maintenance required.

5. Close recovery tank and reinstall latch and screw.

MAINTENANCE

Figure 9

Figure 10

Figure 11

Advertising