Chicago Electric 90636 - Manual (Page 3)

SKU 90636 For technicial questions, please call 1-800-444-3353. Page 3
7. Maintain tools with care. Keep clean. Do not use a damaged tool. Tag damaged
tools “Do not use” until repaired.
8. Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
9. Maintain labels and nameplates on this
tool. These carry important information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
10. Always wear ANSI approved safety
impact eye goggles and heavy work
gloves when using this tool. Using
personal safety devices reduce the risk
for injury. Safety impact eye goggles and
heavy work gloves are available from
Harbor Freight Tools.
11. Maintain a safe working environment. Keep the work area well lit. Make sure
there is adequate surrounding workspace. Always keep the work area free of
obstructions, grease, oil, trash, and other debris. Do not use this tool in areas
near flammable chemicals, dusts, and vapors. Do not use this product in a
damp or wet location.
WARNING! People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a
heart pacemaker could cause interference or failure of the pacemaker.
SPECIFIC SAFETY RULES FOR THE BATTERY TESTER
1. When connecting the Battery Cables to the battery, avoid creating sparks (always
connect and disconnect clamps exactly as described in rule number 2, below,
and on page 4), especially when the battery is being charged. Explosive gases
are created during charging. Sparking could also damage the vehicle electrical
system.
2. Be certain of the test battery polarity before connecting the test Cable Clamps.
The red Cable Clamp (A) goes to the positive terminal of the battery. The black
Cable Clamp (B) goes to the negative terminal of the battery.
3. When placing the Battery Tester in the vehicle (on the frame, engine, or fender),
take special care that the metal housing of the Battery Tester does not come in
contact with either terminal of the battery or other electrical connections.
4. Do not drop the Battery Tester as it may affect proper operation.
5. Do not smoke or have open flames near the battery.
CAUTION!
Battery acid may cause severe
injury to eyes; always wear ANSI
approved safety goggles. Avoid
touching eyes while working with or
near a battery. In case of accidental
contact, rinse eyes with clean
water for at least 5 minutes and
see a doctor immediately.