Cabletron Systems SEHI-32 - Manual (Page 78)

LOCAL MANAGEMENT
Page 6-21
Walking Through OIDs
To walk through an OID:
1. Highlight Walk, using the arrow keys, then press the Return key.
“<INITIAL> OID (=|F9)” appears.
2. Enter the OID (minus the prepend) and press the Return key. The
screen will begin walking through the sublayers of the MIB
available from the specified OID. Each OID listed displays the
specified OID, its size, its type, and the data it contains.
3. Press the Space Bar to stop the walk, or wait for “***MIB WALK
COMPLETED***” to appear on the screen.
Stepping Through OIDs
To step through an OID (you can step through only after a GetNext):
1. Highlight Step, using the arrow keys, then press the Return key.
“Specify OID” appears.
2. Enter the OID (only the suffix is necessary) and press Return. The
Tools screen will begin to scroll one OID at a time, through all of
the sublayers of the MIB available for that OID.
Cycling Through OIDs
To cycle through an OID:
1. Use the arrow keys to Highlight CYCLES, then press Return.
2. Enter the number of cycles that you want to occur after “ENTER
CYCLE COUNT:”, then press the Return key.
3. Enter how many seconds delay that you want between get next
requests after “ENTER CYCLE DELAY (secs):”, then press the
Return key.