Dell OptiPlex 3010 (Mid 2012) - Manual (Page 22)

Related Links
Installing the Power Switch Cable
Installing the Power-Switch Cable
1. Slide the power-switch cable in through the front of the computer.
2. Secure the power-switch cable to the chassis.
3. Thread the power-switch cable into the chassis clips.
4. Connect the power-switch cable to the system board.
5. Install the optical drive .
6. Install the front bezel .
7. Install the cover .
8. Follow the procedures in After Working Inside Your Computer .
Related Links
Removing the Power Switch Cable
Removing the Front Thermal Sensor
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the cover .
3. Disconnect the thermal-sensor cable from the system board.
4. Unthread the thermal-sensor cable from the chassis clip.
22