Dell POWEREDGE M1000E - Manual (Page 919)

38-27
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 38 Configuring IP Unicast Routing
Configuring OSPF
Note To enable OSPF, the switch or stack master must be running the IP services feature set.
Default OSPF Configuration
Table 38-5 shows the default OSPF configuration.
Table 38-5 Default OSPF Configuration
Feature Default Setting
Interface parameters Cost: No default cost predefined.
Resend interval: 5 seconds.
Send delay: 1 second.
Priority: 1.
Hello interval: 10 seconds.
Dead interval: 4 times the hello interval.
No authentication.
No password specified.
MD5 authentication disabled.
Area Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
Auto cost 100 Mb/s.
Default-information originate Disabled. When enabled, the default metric setting is 10, and the
external route type default is Type 2.
Default metric Built-in, automatic metric translation, as appropriate for each
routing protocol.
Distance OSPF dist1 (all routes within an area): 110.
dist2 (all routes from one area to another): 110.
dist3 (routes from other routing domains): 110.
OSPF database filter Disabled. All outgoing link-state advertisements (LSAs) are
flooded to the interface.
IP OSPF name lookup Disabled.
Log adjacency changes Enabled.
Neighbor None specified.
Neighbor database filter Disabled. All outgoing LSAs are flooded to the neighbor.
Network area Disabled.