Dell PowerEdge C8000 - Manual (Page 271)

Installing System Components 271
Installing the Back GPGPU Card Riser
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION: If you are installing a new GPGPU card riser, ensure that it is installed
on the sled cover with the proper screw holes. If the GPGPU card riser is not
installed with the correct screw holes, the GPGPU card will not seat properly into
the riser connector. See "Back GPGPU Card Riser Screw Locations" on page 271
for the location of the screw holes.
Back GPGPU Card Riser Screw Locations
The back GPGPU card riser has four screw holes (see Figure 3-90) and each
pair is marked "type A" and "type B" and can be used to mount a specific type
of GPGPU/Xeon Phi card.
See "GPGPU/Xeon Phi Cards" on page 211 for more information.
Screw Hole Type GPGPU/Xeon Phi Card
Type A • Intel Xeon Phi 5110P card
• Intel Xeon Phi 7120P card
Type B • NVIDIA Tesla K10 GPGPU card
• NVIDIA Grid K2 GPGPU card
• NVIDIA Tesla K20 GPGPU card