Dell PowerVault DP500 - Manual (Page 31)

DPM Reinstallation
31
• All users must be logged on as domain users and be a member of the local
administrators group.
To configure your system to meet these requirements, refer to the following
sections in the Dell PowerVault Data Protection Solution Quick Start Guide:
• "Network Configuration"
• "Changing the Computer Name"
• "Joining a Domain and Adding the Domain User to Local Administrator's
Group"
Virtual Disk Configuration for the DPM Storage Pool
The DPM application requires dedicated disk storage to store the replicas
from the protected systems. You must create one or more RAID 5 virtual disks
for this purpose.
Use OMSA to create the virtual disks to be used by DPM. Refer to the
"Configuring Virtual Disks for DPM" section of the PowerVault Data
Protection Solution Storage Expansion Guide.
NOTE:
Do not add available or free disks to the DPM Storage pool at this time. That
task will be performed automatically when you run the PowerVault Data Protection
Solution Configuration Wizard after installing the DPM application.
DPM Installation
To install DPM, use the Reinstallation DVD with Multilingual Support -
Microsoft System Center Data Protection Manager 2007 media that shipped
with your system. Installation steps are below.
1 Log on to the system using a domain user account that is a member of the
local administrators group.
2 Insert the Reinstallation DVD with Multilingual Support - Microsoft
System Center Data Protection Manager 2007 media. If the DPM Setup
Wizard does not start automatically, double-click Setup.exe in the root
folder of the DVD.
3 At the Microsoft System Center Data Protection Manager 2007 screen,
click Install Data Protection Manager.
4 On the Microsoft Software License Terms page, review the license
agreement and accept the terms.