Casio KL-7400 - Manual (Page 55)

E 52
Symptom Recommended Action Possible Cause
The tape
will not cut.
The printer
will not half
cut.
The label is too short.
The tape cutter is dull.
FULL CUT or UNCUT
is selected for the tape
cut mode.
You are printing on
magnetic tape.
The label is too short.
Less than approximately
28mm (1 1/8") with
narrow margins
Less than approximately
35mm (1 3/8") with
medium margins
Less than approximately
44mm (1 3/4") with wide
margins
Use scissors to cut the labels
after printing is complete.
Have the tape cutter replaced
by your retailer or your local
CASIO service center.
Change the tape cut mode
setting to CONT HALF CUT
or FULL+HALF CUT.
Half cutting is not supported
for magnetic tape. Use
scissors to cut the labels after
printing is complete.
• Select UNCUT for the tape
cut mode whenever printing
on magnetic tape or reflective
tape (page 21).
Use scissors to cut the labels
after printing is complete.
Less than approximately
28mm (1 1/8") with
narrow margins
Less than approximately
35mm (1 3/8") with
medium margins
Less than approximately
44mm (1 3/4") with wide
margins
Symptom Recommended Action Possible Cause
The label
does not
stick.
Label
margins are
too wide.
The backing paper has
not been removed.
The location or the
surface is not
compatible.
WIDE or MEDIUM is
selected for the margin
setting of the format
being used.
Remove the backing paper.
(page 19)
Do not try to affix a label to a
surface that is rough, wet, oily,
or dirty. (page 19)
Change the margin setting to
NARROW or NONE. (page
29)
Note that the printer is
designed always to insert a
margin at the start of a label
print.