Dell PowerVault 715N (Rackmount NAS Appliance) User Manual
Page 5
18. Click OK to close the connection window.
The Connect box prompts you for a user name and password.
NOTE:
The default administrative user name is administrator and the default password is powervault.
19. Ensure that your NAS system is on and that it has had sufficient time to boot into the Windows operating system.
20. Start a Web browser on the client system you are using to configure the NAS system.
21. Type https://192.168.192.1:1279 in the browser and press <Enter>.
192.168.192.1 is the IP address used by your NAS system for this serial cable connection.
22. Click Yes to accept the security certificate.
If a message states that the name on the security certificate is invalid or does not match the name of the site,
ignore the message and click Yes.
23. Enter the administrative user name and password for your system when prompted, and then click OK.
NOTE:
The default administrative user name is administrator and the default password is powervault.
The NAS Manager is displayed. After the NAS Manager is displayed, you can configure your system through the NAS
Manager or through the Terminal Service Client. See "
" in "NAS Manager."
Connecting to the NAS System
This section assumes that you have already configured your client system to connect to the NAS system. If you have not
configured the client system, see "
Setting Up the Windows 2000 Client for the First Time
."
1. Ensure that your NAS system is on and that it has had sufficient time to boot into the Windows operating system.
NOTE:
The NAS system takes approximately 5 minutes to boot. You should allow an additional 5 minutes for
the serial connection service on your NAS system to start.
2. On the client system that is connected to the NAS system, right-click My Network Places on the desktop, and
click Properties.
The Network and Dial-up Connections window appears.
3. Double-click the connection you created in "
Setting Up the Windows 2000 Client for the First Time
."
4. Enter the administrative user name and password for your NAS system.
NOTE:
The default administrative user name is administrator and the default password is powervault.
5. Click Connect.
This action connects the client system to the NAS system through the serial cable.
6. Start a Web browser on the client system you are using to configure the NAS system.
7. Type https://192.168.192.1:1279 in the browser and press <Enter>.
192.168.192.1 is the IP address used by your NAS system for this serial cable connection.
8. Click Yes to accept the security certificate.
If a message states that the name on the security certificate is invalid or does not match the name of the site,
ignore the message and click Yes.