Dell Latitude E6400 - Manual (Page 48)

Back to Contents Page
FCM
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Removing an FCM from the WWAN/FCM Slot
Removing an FCM from the WPAN/UWB/FCM Slot
Replacing an FCM
The FCM is also known as Intel® Turbo Memory and the Intel Flash Cache Logic Chip Mini-card. You can install an FCM in either the WWAN/FCM card connector
or the WPAN/UWB/FCM card connector.
Removing an FCM from the WWAN/FCM Slot
1. Follow the procedures in Before Working on Your Computer .
2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly ).
3. Remove the M2 x 3-mm screw. The FCM pops up at a 45-degree angle.
4. Slide the FCM out of the card connector on the system board.
Removing an FCM from the WPAN/UWB/FCM Slot
1. Follow the procedures in Working on Your Computer .
2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly ).
3. Remove the M2.5 x 5-mm screw from the left hinge cover, and slide it forward then lift to remove it.
4. Remove the M2 x 3-mm screw. The FCM pops up at a 45-degree angle.
5. Slide the FCM out of the card connector on the system.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTE: This module is only compatible with the Microsoft® Windows Vista® operating system.
1 M2 x 3-mm screw 2 card connector
3 FCM