Dell Inspiron 700M User Manual
Page 74
74
Adding and Replacing Parts
www
.dell.com | support.dell.com
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the
memory-module securing clips.
3 If you are replacing a memory module, remove the existing module:
a
Use your fingertips to carefully spread apart the securing clips on each end of the memory
module connector until the module pops up.
b
Remove the module from the connector.
4 Ground yourself and install the new memory module:
NOTE:
If the memory module is not installed properly, the computer may not boot properly. No error
message indicates this failure.
a
Align the notch in the module edge connector with the tab in the connector slot.
b
Slide the module firmly into the slot at a 45-degree angle, and rotate the module down
until it clicks into place. If you do not feel the click, remove the module and reinstall it.
5 Replace the cover.
NOTICE:
If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close
may damage your computer.