Dell Dimension E521 - Manual (Page 93)

Removing and Installing Parts
93
3 Disconnect the power and data cables from the back of the floppy drive.
NOTE:
If you have installed a PCI Express x16 card, this card may cover the floppy-drive connectors. Remove this
card before disconnecting the floppy-drive cables (see "Removing a PCI Express Card " on page 80 )
4 Slide the drive latch release toward the bottom of the computer and, without releasing the drive latch
release, slide the floppy drive out through the front of the computer.
5 If you are not replacing the drive, reinstall the drive panel insert (see "Replacing the Drive-Panel Insert"
on page 83).
6 Replace the computer cover (see "Replacing the Computer Cover" on page 105).
7 Connect your computer and devices to electrical outlets, and then turn them on.
8
Check the System Step for the appropriate diskette Drive Option changes (see "Entering System Setup " on
page 111 ).
1 drive latch release 2 sliding plate 3 floppy drive
3
2
1
book.book Page 93 Monday, July 23, 2007 3:47 PM