Dell V715w All In One Wireless Inkjet Printer User Manual
Page 138
2
Ping the access point:
a
Click
, or click Start and then click Run.
b
In the Start Search or Run box, type cmd.
c
Press Enter, or click OK.
The Command Prompt window opens.
d
Type ping followed by a space and the IP address of the wireless access point. For example:
ping 192.168.1.100
e
Press Enter.
3
Check to see whether the access point responds:
•
If the access point responds, you will see several lines appear that start with “Reply from.”
It is possible that the printer did not connect to the wireless network. Turn off and then restart the printer
to try to connect again.
•
If the access point does not respond, it will take several seconds and then you will see “Request timed out.”
Try the following:
a
Click
, or click Start and then click Run.
b
In the Start Search or Run box, type ncpa.cpl, and then press Enter.
c
Press Enter or click OK.
d
Select the appropriate connection from the ones shown.
e
Right-click the connection, and then click Repair.
M
AKE
SURE
YOUR
COMPUTER
CAN
COMMUNICATE
WITH
THE
PRINTER
1
Obtain the printer IP address by printing a network setup page.
2
Click
, or click Start and then click Run.
3
In the Start Search or Run box, type cmd.
4
Press Enter, or click OK.
The Command Prompt window opens.
5
Type ping followed by a space and the IP address of the printer. For example:
ping 192.168.1.100
6
Press Enter.
7
If the printer responds, you will see several lines that display the number of bytes received from the printer.
This ensures that your computer is communicating with your printer.
If the printer does not respond, then “Request timed out” displays.
•
Your computer might not be connected to the network.
•
You may need to change the settings of your printer. Run the Wireless Setup Utility again.
C
ONFIGURE
THE
PRINTER
FOR
WIRELESS
ACCESS
AGAIN
If your wireless settings have changed, you must run the printer wireless setup again. Some reasons your settings
may have changed include your having manually changed your WEP or WPA keys, channel, or other network
settings; or the access point having been reset to factory defaults.
Troubleshooting
138