Dell OptiPlex E1 - Manual (Page 103)

Installing System Board Options 6-13
 5HPRYH WKH FRPSXWHU FRYHU DFFRUGLQJ WR WKH LQVWUXFWLRQV LQ ´5HPRYLQJ
WKH &RPSXWHU &RYHUµ LQ &KDSWHU 
 /RFDWH WKH EDWWHU\ DQG UHPRYH LW
The battery (see Figure 6-1) is mounted in a socket labeled “BATTERY,” in the
front-right corner of the system board (as you face the front of the system).
&$87,21 ,I \RX SU\ WKH EDWWHU\ RXW RI LWV VRFNHW ZLWK D EOXQW REMHFW EH
FDUHIXO QRW WR WRXFK WKH V\VWHP ERDUG ZLWK WKH REMHFW 0DNH FHUWDLQ WKDW
WKH REMHFW LV LQVHUWHG EHWZHHQ WKH EDWWHU\ DQG WKH VRFNHW EHIRUH
DWWHPSWLQJ WR SU\ RXW WKH EDWWHU\ 2WKHUZLVH \RX PD\ GDPDJH WKH V\V
WHP ERDUG E\ SU\LQJ RII WKH VRFNHW RU E\ EUHDNLQJ FLUFXLW WUDFHV RQ WKH
V\VWHP ERDUG
Pry the battery out of its socket with your fingers or with a blunt, nonconductive
object, such as a plastic screwdriver.
 ,QVWDOO WKH QHZ EDWWHU\
Orient the battery with the side labeled “+” facing up (see Figure 6-10). Then
insert the battery into the socket, and snap it into place.
)LJXUH  6\VWHP %DWWHU\ DQG %DWWHU\ 6RFNHW
 5HSODFH WKH FRPSXWHU FRYHU UHFRQQHFW \RXU FRPSXWHU DQG SHULSKHUDOV
WR WKHLU HOHFWULFDO RXWOHWV DQG WXUQ WKHP RQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
 7R UHVHW WKH FKDVVLV LQWUXVLRQ GHWHFWRU HQWHU WKH 6\VWHP 6HWXS SURJUDP
DQG UHVHW &KDVVLV ,QWUXVLRQ WR 1RW 'HWHFWHG
See Chapter 2, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
BATTERY
socket battery