Reports menu, Network card menu – Dell B2360d Mono Laser Printer User Manual
Page 60
Use
To
NPA Mode
Off
Auto
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
•
Auto is the factory default setting.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Network Buffer
Disabled
Auto
3KB to [maximum size allowed]
Set the size of the network input buffer.
Notes:
•
Auto is the factory default setting.
•
The value can be changed in 1
‑KB increments.
•
The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
•
To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Mac Binary PS
On
Off
Auto
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
•
Auto is the factory default setting.
•
Off filters print jobs using the standard protocol.
•
On processes raw binary PostScript print jobs.
Reports menu
To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > Reports
•
Network/Ports > Network [x] > Network [x] Setup > Reports
Use
To
Print Setup Page Print a report containing information about the network printer settings, such as the TCP/IP address.
Network Card menu
To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > Network Card
•
Network/Ports > Network [x] > Network [x] Setup > Network Card
Use
To
View Card Status
Connected
Disconnected
View the connection status of the network card.
Understanding the printer menus
60