Dell A940 All In One Personal Printer - Manual (Page 27)

Using your printer 15
NOTE: To avoid
smearing ink, remove
each transparency or
photo from the paper exit
tray before the next one
exits the printer.
Transparencies and
photos may require up to
15 minutes to dry.
You can load up to: Make sure:
100 sheets of plain paper The paper is designed for use with inkjet printers.
• The envelopes are loaded vertically against the right
side of the paper support.
• The stamp location is in the upper left corner.
• The envelopes are designed for use with inkjet
printers.
• You squeeze and slide the paper guide to the left edge
of the envelope (as shown).
10 envelopes
25 sheets of labels The labels are designed for use with inkjet printers.
10 sheets of card stock • The card stock is designed for use with inkjet printers.
• The thickness does not exceed 0.025 inches.
10 greeting cards, index
cards, postcards, or
photo cards
The cards are loaded vertically against the right side of
the paper support.
25 sheets of coated,
photo, or glossy paper
The glossy or coated side faces you.
10 transparencies • The transparencies are designed for use with inkjet
printers.
• The rough side faces you.
100 sheets of custom size
paper
Your paper size fits within these dimensions:
Width
– 76 to 216 mm
– 3.0 to 8.5 in. Length
– 127 to 432 mm
– 5.0 to 17.0 in.
25 iron-on transfers • You follow the loading instructions on the iron-on
packaging.
• The blank side faces you.
20 sheets of banner
paper
The banner paper is designed for use with inkjet printers.