Dell PowerVault DL2000 User Manual
Page 17
Note:
If you create a virtual disk with an application other than Backup Exec, you
must configure it before Backup Exec uses it as a device for jobs.
See
“Configuring an unconfigured virtual disk for use with Backup Exec”
on page 52.
To configure virtual disks an configuring the Intelligent Disaster Recovery Option
1
From the Dell™ PowerVault™ DL Backup to Disk Appliance Console, start
Backup Exec.
2
Do one of the following:
Do nothing. Upon initial startup, Backup
Exec automatically submits a virtual disk
creation job and begins to create and
configure virtual disks for each disk group
it detects.
If you selected an automatic configuration
policy that does not require a
confirmation
Continue with the following steps.
If you selected an automatic configuration
policy that prompts you for confirmation
3
When the Device Intervention alert appears, review the alert, and then click
Yes.
Backup Exec submits a virtual disk creation utility job. A job named Configure
Storage Array begins to create and configure virtual disks for each disk group
it detects.
4
Click Yes.
5
On the Getting Started with Backup Exec page, click Step 4 - Configure
Intelligent Disaster Recovery to configure the IDR options.
6
After you finish configuring IDR, exit the wizard and then close the Getting
Started with Backup Exec page.
7
Click Close.
See
“About manually creating a virtual disk”
on page 52.
See Using the Getting Started with Backup Exec page in the Symantec Backup
Exec for Windows Systems Administrator's Guide.
See Symantec Backup Exec Intelligent Disaster Recovery Option in the
Symantec Backup Exec for Windows Systems Administrator's Guide.
17
Installing and configuring Backup Exec by using the Storage Provisioning Option
Completing the Backup Exec installation by using the Dell™ PowerVault™ DL Backup to Disk Appliance Configuration
Wizard