Cd/dvd drive – Dell OptiPlex 160L User Manual
Page 77
11.
Install the secondary hard drive:
a.
Place the secondary hard drive in the bracket so that all three screw-hole tabs insert into the three screw holes on the hard drive.
b.
Secure the drive to the bracket with the screws that you removed in
c.
Install the bracket into the computer with the two bracket-securing screws that you removed in
.
12.
Connect the power and data cables to the back of the drives.
Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
13.
Replace the computer cover
.
14.
Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
CD/DVD Drive
1.
Shut down the computer through the Start menu.
2.
Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your computer, turn them off now.
3 bracket tabs (2)
4 front computer frame
5 bracket securing screw
6 drive bracket
7 bracket securing screw
1 primary hard drive
2 secondary hard drive
NOTICE:
Match the black drive connector with the primary hard drive and the grey drive connector with the secondary hard drive.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
CAUTION:
Before you begin this procedure, follow the
safety instructions
.
NOTE:
Drives sold by Dell come with their own operating software and documentation. After you install a drive, see the documentation that came with
the drive for instructions on installing and using the drive software.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.