Crosley Radio Crosley iJuke CR17 - Manual (Page 5)

Using your iJuke Unit Controls
4
1 Power Indicator
2 Power On/Off
3 Lights On/Off
4 Universal Dock
5 Remote Sensor
6 Speakers
7 Mute Indicator
8 Volume Up
9 Volume Down
10 Remote Storage
11 Auxiliary Input (Aux In)
12 Speaker Jacks
13 Internal / External Speaker Switch
(EXT. / INT.)
14 Stage Light Stop & Run Switch
15 DC Jack
7
Basic Operation
The iJuke features the Universal Dock that uses
dock adapters that come with newer iPod models.
Before inserting your iPod, you will need to install
the correct dock adapter. By using the correct dock
adapter, you can insert any iPod with a dock
connector. If you have an older iPod model that did
not come with a dock adapter, they are available on
our website at www.crosleyradio.com or by calling
us at 1-866-Crosley. While docked, the iJuke will
also charge your iPod. To connect your iPod, follow
the steps below. If you’re iPod doesn’t have a dock
connector, you can connect it to the unit by using
the Auxiliary Cable that is supplied.
1
Insert the correct dock adapter that fits your
iPod. Your iPod should fit snugly into the correct
adapter. Gently press the adapter until it snaps
firmly in place.
2
Connect your iPod as shown in the illustration
below.
Note: If your iPod does not have a dock connector, use
the supplied Auxiliary Cable and hook your iPod
to the Auxiliary Input (Aux In) jack on the back
of the unit.
3
Press the Power button to turn iJuke on.
4
Browse your iPod for songs and press the
Play/Pause button. Your music should begin to
play.
5
Adjust the volume to your desired listening level.
6
To remove the dock adapter, push your fingernail
into the slot in the back of the adapter and lift
up.
Control Locator
MUTE
VOL +
albums
extras
VOL -
8
9
7
2
3
1
6
6
10
11 12 13 14 15
5
4