Changing the lamp – Dell S320wi Projector User Manual
Page 134
Changing the Lamp
CAUTION:
Before you begin any of the procedures in this section, follow the
Safety Instructions as described on page 11.
Replace the lamp when the message "Lamp is approaching the end of its
useful life in the operation. Replacement suggested!
" appears on the screen. If this problem persists after
replacing the lamp, contact Dell™. For more information, see Contacting Dell™on
CAUTION:
Use an original lamp to ensure safe and optimal working condition
of your projector.
CAUTION:
The lamp becomes very hot when in use. Do not attempt to replace
the lamp until the projector has been allowed to cool down for at least
30 minutes.
CAUTION:
Do not touch the bulb or the lamp glass at any time. Projector
lamps are very fragile and may shatter if touched. The shattered glass pieces
are sharp and can cause injury.
CAUTION:
If the lamp shatters, remove all broken pieces from the projector
and dispose or recycle according to state, local, or federal law. For more
information see
1
Turn off the projector and disconnect the power cord.
2
Let the projector cool for at least 30 minutes.
3
Loosen the two screws that secure
the lamp cover, and remove the
cover.
4
Loosen the two screws that secure
the lamp.
5
Pull the lamp up by its metal handle.
NOTE:
Dell™ may require lamps
replaced under warranty to be
returned to Dell™. Otherwise,
contact your local waste disposal
agency for the address of the
nearest deposit site.
6
Replace with the new lamp.
7
Tighten the two screws that secure the lamp.
8
Replace the lamp cover and tighten the two screws.
Troubleshooting Your Projector
134