Casablanca Fan Company Casablanca Ceiling Fan PN9943001 - Manual (Page 4)

4
MOTOR
COUPLING
TAPERED
THREAD
MOTOR
WIRES
GROUND
WIRE
Step E. Using the provided allen wrench, loosen the allen set screw.
Thread the downrod into the motor coupling until it stops turning,
this will take at least four and a half full turns.
Step F. Securely tighten the allen set screw with the provided allen
wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the
downrod before securely tightening the
locking bolt may cause the fan to fall during
normal operation!
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN,
INSTALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND
LOCK THE ASSEMBLY
ALLEN
SET SCREW
DOWNROD
&
BALL
ASSEMBLY
Prepare for fan installation as follows:
Step D. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly, keeping the wires
to one side of the cross pin.
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked ‘Approved for ceiling fan mounting’. If it is
not, a new box must be installed.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked
acceptable for ceiling fan support using the mounting
hardware provided with the outlet box. NOTE: The fan weight is 35 pounds.
NOTE: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
ALLEN SET SCREW
1 ⁄
4
-20 x 1 ⁄
4
”
(PRE-INSTALLED)
3mm
ALLEN WRENCH
FAN PREPARATION
GETTING STARTED