Fingerprint reader, Removing the fingerprint reader, Replacing the fingerprint reader – Dell Latitude E6410 User Manual
Page 27
Back to Removing and Replacing Parts
Fingerprint Reader
Dell™ Latitude™ E6410/E6410 ATG Service Manual
Removing the Fingerprint Reader
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
ATG Port Cover
(applicable on E6410 ATG computer only).
3.
Remove the
battery
.
4.
Remove the
optical drive
.
5.
Remove the
access panel
.
6.
Remove the
LED cover
.
7.
Remove the
keyboard
.
8.
Loosen the single captive screw (labeled 'F') on the bottom of the computer, securing the fingerprint reader.
9.
Disconnect the fingerprint reader data cable from the system board.
10.
Peel off the Mylar to release the cable and fingerprint reader from the computer to remove the fingerprint reader.
Replacing the Fingerprint Reader
To replace the fingerprint reader, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.