Dell PowerEdge SC 420 User Manual
Page 53
4.
Remove the battery by pressing on the tab. See
Figure 6-6. Replacing the Battery
5.
Install the new battery with the side labeled "+" facing up, and press down until it snaps into place.
6.
Close the system. See "
Closing the System
" in "Troubleshooting Your System."
7.
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
8.
Enter the System Setup program to confirm that the battery operates properly.
9.
From the main screen, select System Time to enter the correct time and date.
Also, re-enter any system configuration information that is no longer displayed on the System Setup screens, and then exit the System Setup program.
10.
To test the newly installed battery, turn off the system and disconnect it from electrical power for at least an hour.
11.
After an hour, reconnect the system to a power source and turn it on.
12.
Enter the System Setup program. If the time and date are still incorrect, see "
Getting Help
."
13.
Properly dispose of the old battery. For more information, see your Product Information Guide.
Back to Contents Page