Dell PowerEdge VRTX - Manual (Page 35)

Shutdown Procedure For Servicing A Hard Drive/SSD
This section applies only to situations where the server module must be powered down to service a hard
drive/SSD. In many situations, the hard drive/SSD can be serviced while the server module is powered on.
CAUTION: If you need to power off the server module to service a hard drive/SSD, wait 30
seconds after the server module’s power indicator turns off before removing the hard drive/SSD.
Otherwise, the hard drive/SSD may not be recognized after it is reinstalled and the server module
is powered on again.
Configuring The Boot Drive
The drive or device from which the system boots is determined by the boot order specified in the System
Setup.
Removing A Hard Drive/SSD From A Hard-Drive/SSD Carrier
1. Remove the four screws from the slide rails on the hard-drive/SSD carrier.
2. Lift the hard drive/SSD out of the hard-drive/SSD carrier.
Figure 9. Removing and Installing a Hard Drive/SSD in a Hard-Drive/SSD Carrier
1. hard drive/SSD 2. screw holes (4)
3. hard-drive/SSD carrier 4. screws (4)
35