Dell PowerEdge R300 - Manual (Page 115)

Installing System Components
115
Figure 3-22. Installing and Removing the Control Panel Assembly
NOTE:
In the preceding figure, the 12C cable is shown connecting over the control
panel cabling. This cable should be routed under the control panel cable and the
internal USB key connector. The 12C cable seats in a cable guide clip that is directly
beneath the control panel connector.
5 Disconnect the internal USB key cable and, if applicable, the hard-drive
backplane 12C cable. See "Installing the Optional Internal USB Memory
Key" on page 91 and "Removing the Backplane Board" on page 101.
1 display-module label 2 display-module securing screws (2)
3 display module 4 display-module cable
5 control-panel cable 6 control-panel circuit board securing
screws (3)
7 control-panel circuit board
7
2
3 4
6
1
5
book.book Page 115 Sunday, June 21, 2009 5:16 PM