Dell POWERVAULT MD3620I - Manual (Page 73)

Configuration: About Your Storage Array 73
The Name/Rename Storage Arrays dialog is displayed.
2 Select the relevant storage array from the Select storage array table.
If you do not know the name or physical location of the storage array, click
Blink. After locating the storage array, click OK to turn off the LEDs.
The name of the storage array is displayed in the
Storage array name.
3 In Storage array name, type the new name of the storage array. If
applicable, add a comment for the storage array in Additional comment.
4 Click Apply.
A message is displayed warning you about the implications of changing the
storage array name.
5 Click Yes.
The new storage array name is displayed in the Select storage array table.
6 Repeat step 2 through step 4 to name or rename additional storage arrays.
NOTE: Avoid arbitrary names or names that may lose meaning in the future.
Setting a Password
You can configure each storage array with a password to protect it from
unauthorized access. MDSM prompts for the password when an attempt is
made to change the storage array configuration, such as, when a virtual disk is
created or deleted. View operations do not change the storage array
configuration and do not require a password. You can create a new password
or change an existing password.
NOTE: It is recommended that you use a long password with at least 15
alphanumeric characters to increase security.
To set a new password or change an existing password:
1 Select the relevant storage array and navigate to the AMW for that storage
array. See "Array Management Window" on page 63.
The AMW for the selected storage array is displayed.
2 In the AMW, perform one of these actions:
• Select the storage array in the Logical pane, and then select Storage
Array Set Password.
book.book Page 73 Tuesday, June 18, 2013 3:09 PM