Dell PowerEdge 850 - Manual (Page 113)

14. If possible, restore the files to the drive.
If the problem persists, see " Getting Help ."
Troubleshooting SATA Hard Drives
Troubleshooting a SATA Hard Drive
Problem
l Faulty hard drive
l Damaged or improperly connected hard-drive cables
Action
1. Run the appropriate online diagnostic test. See " Using Server Administrator Diagnostics " in "Running the System Diagnostics."
2. Enter the System Setup program and verify that the system is configured correctly. See "Using the System Setup Program" in your User's Guide.
3. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
4. Open the system. See " Opening the System ."
5. Ensure that the hard-drive interface cable is properly connected between the drive and the system board.
To identify system board connectors, see Figure A -3 .
6. If the hard drive is the boot drive, ensure that the drive is configured and connected properly. See " Configuring the Boot Drive " in "Installing Drives."
7. Ensure that the power cable is properly connected to the drive.
8. Close the system. See " Closing the System ."
9. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
10. Format and partition the hard drive. See the operating system documentation.
11. If possible, restore the files to the drive.
If the problem persists, see " Getting Help ."
Troubleshooting a SATA Hard Drive in a RAID Configuration
Problem
l Device driver error
l Damaged or improperly connected hard-drive cables
Action
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer and protecting against electrostatic discharge.
NOTICE: This troubleshooting procedure can destroy data stored on the hard drive. Before you proceed, back up all files on the hard drive.
NOTE: If the hard drive is used in a RAID configuration, see " Troubleshooting a SATA Hard Drive in a RAID Configuration ."